≡ Menu

Freightliner Columbia Trucks Factory Service Workshop Manual

Freightliner Columbia Trucks Factory Service Workshop Manual
Columbia CL112,CL120
Service starting fluid systems only in a wellventilated area away from sparks and open flames. The ethyl ether in these systems is flammable and toxic. Wear protective gloves and glasses, and avoid breathing ether fumes. Failure to take these precautions could result in personal injury or property damage.
Freightliner Columbia Trucks Factory Service Workshop Manual

Freightliner Columbia Trucks Factory Service Workshop Manual

Freightliner Columbia Trucks Factory Service Workshop Manual
Freightliner Columbia Trucks Factory Service Workshop Manual
Free shipping by email
Price: $39.99

NOTE: If not replacing the cylinder immediately, place the valve cap in the valve to prevent dirt
or other debris from entering the system. Freightliner Columbia Workshop
4. Remove the old dirt eliminator collar from the valve assembly.
5. Replace the Dieselmatic valve gasket. Spread the new gasket with a light film of clean oil.
6. Place a new dirt eliminator collar, adhesive-side up, on the valve assembly. Peel off the collar’s
paper backing to expose the adhesive.
7. Install the new cylinder.
7.1 Place the new cylinder into the Dieselmatic valve and hand tighten it firmly.
7.2 Slide the dirt eliminator collar up so it sticks to the cylinder.
7.3 Tighten the clamp around the cylinder 60 lbf·in (680 N·cm).
8. If the ambient temperature is below 40°F (4°C), test the starting fuel system.
9. Lower the hood, and remove the chocks from the tires.

Freightliner Columbia Trucks Factory Service Workshop Manual